Crestron CEN-GW1 Quick Start Manual

CEN-GW1 and CENI-GW1
Universal Wireless Gateway - ER, SG, and infiNET EX® Wireless Networks
The CEN-GW1 and CENI-GW1 are universal wireless gateways that
communicate with Crestron® SG (Sub GHz), ER (Extended Range), and
infiNET EX® wireless devices. A single CEN-GW1 creates SG, ER, and
infiNET EX® wireless networks to facilitate 2-way communication
between a Crestron® control system and a network of Crestron wireless
remotes, keypads, lighting dimmers, motorized shades, thermostats,
door locks, and other wireless devices.
NOTE: The CEN-GW1 and CENI-GW1 are functionally similar. For
simplicity within this guide, the term "CEN-GW1" is used except
where noted.
The CEN-GW1 is powered via PoE (Power over Ethernet) or with an
optional power pack (PW-2407WU, sold separately).
In the Box
1 CEN-GW1 or CENI-GW1, Universal Wireless Gateway
Additional Items
1 Bracket, Mounting, Integrated DIN Rail Clip (4519035)
1 Antenna, EX/ER, 2.4 GHz, 1/4 Wave, Reverse Polarity,
Female (2001016)
1 Cable, Ethernet, CAT5e, 5 ft (1.52 m) (2022311)
2 Screw, 6-32 x 3/8 in., Pan Head, Phillips (2007225)
CEN-GW1 Only
1 Antenna with Yellow Stripes, SG, 916 MHz, 1/2 wave,
Reverse Polarity, Female (2055721)
CENI-GW1 Only
Antenna with Gray Stripes, SG, 868 MHz, 1/2 wave,
1
Reverse Polarity, Female (2055720)

Determine the Installation Location

Install the CEN-GW1 in a location that will provide optimum
performance. Consider the following when determining the installation
location:
NOTE: For additional information, refer to the
Setup of Crestron RF Products Best Practices Guide
Place the gateway at least 15 ft (4.6 m) from other SG (Sub GHz),
l
infiNET EX gateways, Crestron ER gateways, or Wi-Fi® access points.
Place multiple gateways on different RF channels.
l
Place the gateway at least 6 ft (1.8 m) from the nearest Bluetooth®
l
device.
Quick Start
Installation and
(Doc. 6689).
1