Product Description - TEFAL QUICK & HOT AQUA BR303 Manual

Notice Tefal AQUA 0827778:Mise en page 1
Thank you for purchasing this Tefal water heater. Please read the instructions common to all of our
models carefully and keep them in a safe place..

Product description (

A
water tank
B
tank lid
C
water release valve
D
body of the appliance
E
nozzle or water outlet
1 Remove all of the packaging, stickers or accessories from the interior and exterior of the appliance.
2 Remove the tank
3 Then fill the tank
valve C is properly engaged
4 Plug in the appliance.
5 Place a container that holds approximately 1.5 litres under the nozzle
6 Hold down the hot water button
When operating for the first time, it is normal that a little steam escapes from the nozzle
7 When the container is almost full, release the hot water button
Installation of the CLARIS filter cartridge
(according to model)
• To get the best taste and performance from your appliance we advise you to use the Claris Aqua Filter
System cartridge. This cartridge contains an anti-lime substance and activated carbon that reduces
chlorine, impurities, lead, copper, pesticides, etc that are present in water. Minerals and trace elements,
however, are preserved.
1 Unwrap the cartridge J. Take note of the month in which the cartridge is put into use by sliding the upper
ring on the filter to the use start date
6 weeks (or every 50 litres), according to the hardness of your water.
2 Position the cartridge in the tank
Certain models also have an indicator light
For these models, when this light
3 To change the cartridge, remove the used cartridge and replace it with a new Claris Aqua Filter system
cartridge, sold as an accessory (ref XH 5000)
4 For models with an indicator light, it is necessary to record the change of cartridge by simultaneously
pressing the hot water button
After 5 seconds, the indicator light will go out. The appliance will then have recorded the cartridge change.
• The Claris Aqua Filter cartridge can be installed in all Tefal models, including those that do not have a fil-
ter on purchase.
All manuals and user guides at all-guides.com
)
fig. 1
Rinsing before using for the first time
A
and clean it in water, taking care that no particles remain in the tank.
A
with cold water and reposition it firmly on its base
fig 1a 1b 2.
, and
H
: hot water will begin to run out
fig 4
A
and screw the cartridge
K
, which indicates when it is necessary to change the cartridge.
K
flashes during use, it is time to change the cartridge
H
and the ambient water button
9/05/07 17:05 Page 11
G
lukewarm water button
H
hot water button
I
quantity selector (according to model)
J
filter cartridge (according to model)
K
cartridge change and descaling indicator light
(according to model)
D
E.
fig 3.
H
to stop the flow. Discard the water.
. You should change your Claris Filter Cartridge every 4 to
J
a quarter turn into the bottom of the tank.
fig 6
.
G
, for at least 5 seconds
, making sure that the release
E
.
fig 5
.
fig 7.
GB
11