Operating Precautions-Warnings - MOXTEK X-ray Sources MOX-HPC150 Max Operation Manual

Operating Precautions-Warnings

Caution Verify that the tube and the high voltage power supply are properly grounded before powering the tube on.
Caution MoxHPC tubes contain beryllium. Inhaling Beryllium dust may cause lung disease – refer to the MSDS.
Under normal use, Beryllium dust is not generated. If the Beryllium target is broken, a very small amount of
dust might be generated. If this occurs follow the instructions on the MSDS for cleanup.
MoxHPC X-ray tubes may become very hot during operation.
Warning
MoxHPC X-ray tubes produce x-ray radiation. HPC tubes are shielded with a metal shield and high-Z
Warning
potting materials. Extra shielding may be required depending on the application. ONLY OPERATE X-RAY
TUBES IN PROPERLY SHIELDED ENCLOSURES. It is the responsibility of the operator to ensure that
all applicable safety precautions are taken and observed.
MoxHPC X-ray tubes operate at high voltages Refer to the cable preparation instructions on page 4.
Warning
Precautions should be taken to protect the operator while applying high voltages to avoid serious injury or
death.
452 West 1260 North / Orem, UT 84057
Phone 801.225.0930 / Fax 801.221.1121
www.moxtek.com
info@Moxtek.com
MOXTEK
®
For warranty and ordering information, please visit www.moxtek.com.
TUB-MAN-1020 Rev C
Subject to technical change without notice
7