Disabling Modes From The Remote - Travis Industries GS2 Installation Manual

Disabling Modes From the Remote

NOTE: The remote is shipped with the modes disabled. These instructions are for reference purposes only.
1 Remove one battery from the remote.
2 Press down on the on/off button and mode button while replacing the battery.
Make sure to keep the on/off button depressed during the following steps.
3 While keeping the on/off button depressed, press and release the mode button until the mode that needs to
be changed is illuminated.
4 With the desired mode illuminated (the illustration below shows the AUX mode illuminated), press the "up" or
"down" button to activate or clear the mode being addressed. Make sure to keep the on/off button depressed
during this process.
5 Release the on/off button to complete programming.
Page 13 of 13
GS2 Basic Wall Mount Remote Operation
HINT: The easiest way to do this step is to place the top
17601967 - 2/12/19
SKU# 99300695
battery in the holder, slightly ajar. Then hold the the
buttons down as you press the battery into place.
Optional
Standing
Flame
Pilot
Height
Blower
Accent
Comfort
Light
Control
Press the "up" button to activate
("SET") the mode selected.
Press the "down" button to clear
("CLR") the mode selected.
Travis Industries, Inc.
AUX