Table of Contents
Advertisement
BEFORE YOU BEGIN:
Note
The pilot flame must be lit, the gas control valve turned to "ON", and the on/off
switch turned to "OFF".
Warning
Read all of the safety precautions in the owner's manual included with your heater
before using this remote control.
MODES OF OPERATION:
The thermostat can be operated in the following modes:
Manual
Use the remote to turn the
heater on and off.
NOTE : If left on, the heater
will turn off after 6 hours.
Auto
Let the remote automatically
turn the heater on when it is
too cool, turn it off when it is
too hot. You set the desired
temperature with the remote.
Page 1 of 4
Operating Instructions
10850 117th Place N.E. Kirkland, WA 98033
TO SET TO MANUAL:
By pressing this
button, the remote
automatically enters
manual mode.
TO TURN ON AND OFF:
Use this key to toggle the
heater on and off. The
display will indicate the
status.
TO SET TO
THERMOSTAT MODE:
Use this key to toggle
the thermostat mode
on. The display will
indicate "Auto" in the
ROOM TEMP
lower left.
HINT:
If your heater turns on
and off frequently, adjust
the flame height down
slightly for a more
consistent heat output.
°F
°F
SET TEMP
ROOM TEMP
:
PM
Set
TO ADJUST TARGET
TEMPERATURE:
Use the arrow keys to adjust
the target temperature to the
°F
°F
SET TEMP
desired level.
:
PM
The heater will turn on and
off to keep the room
temperature near the target
temperature.
Set
IMPORTANT OPERATIONAL
NOTE:
The thermostat has a built-in
time delay to keep the heater
from constantly turning on and
off. This means the target
temperature may be slightly
higher (2° or 3°) than the room
temperature – do not adjust the
target temperature – the heate
will turn on in a few minutes.
Printed November 2, 2000
Advertisement
Table of Contents
