Wall Mount And Hand Held Remote; Remote Setup - Travis Industries GreenSmart 2 Setup Instructions

Wall Mount and Hand Held Remote

These instructions apply to both the wall mount and hand held remotes (both are identical in operation).
For ease of reference, the wall mount button layout is shown in the instructions. If using the hand held
remote, make sure to use the correct button by looking at the icon on the button (both remotes have icons
on the buttons that are identical – see illustration below).

Remote Setup

Verify the Switch is on "REMOTE"
The battery holder has a switch built into it. This switch must remain in the REMOTE position for the
remote to operate (see illustration below).
Synchronize the Transmitter to the IFC
The transmitter will need to be synchronized to the IFC (Integrated Fireplace Control) before the remote
will work correctly. Synchronizing is done in the following two steps below (see illustration below):
1. Press the PRG (Program) button on the battery box (IFC will beep 3 times).
2. Press the "ON" button on the transmitter (IFC will beep 3 times).
NOTE: If power is cut off to the IFC for an extended period of time, you may need to re-synchronize the remote.
Clearing the System Memory
This appliance uses an Integrated Fireplace Control (IFC) to store the unique code for the remote control.
If you wish to clear the system memory, MAKE SURE GAS IS TURNED OFF TO THE APPLIANCE then
press the PRG (Program) button for 10 seconds. The pilot will start to spark repeatedly, signifying all
system memory has been cleared. The system will return to its original configuration: a remote will need
to be synchronized; and, the system will operate under continuous pilot mode.
Page 2 of 10
GreenSmart
(SKU 99300688, 99300690, 99300692, 99300693)
Hand Held Remote Buttons
"Beep"
"Beep"
"Beep"
17601740.docx — 11/3/16
TM
2 Remote Setup Instructions
Wall Mount Remote Buttons
"Beep"
"Beep"
"Beep"
© Travis Industries, Inc.