Mv Stove Installation - Travis Industries GS2 Installation Manual

MV Stove Installation

This set of installation instructions shows a summary of the remote installation.
For detailed instructions on placement of the receiver and other details, refer to the
installation manual included with your appliance.
1 Locate the Green and White wires labeled "REMOTE" near the gas control valve. Connect the Green and
White wires from the back of the remote to the "REMOTE" wires found in step 1.
2 Remove clear plastic film from the Velcro strips on the bottom of the heatshield for the receiver. Turn the
assembly over so the strips are facing downward. Gently push the wires back into the appliance as you move
the receiver assembly into place. Adhere the assembly to the floor of the controls area of the stove. Make
sure the placement does not obstruct the movement of the door.
3 Verify the wiring does not contact any hot or moving components. Restore the appliance to the correct
configuration. Install the batteries in the remote and receiver. Synchronize the remote to the receiver (page
9).
Page 3 of 13
GS2 Basic Wall Mount Remote Installation
17601967 - 2/12/19
SKU# 99300695
Travis Industries, Inc.