Warranty - Weller WE 1 Translation Of The Original Instructions

EN
ENGLISH
User groups
Due to differing degrees of risk and potential hazards, sever-
Work step
Default soldering para-
meters
Replacing electrical repla-
cement parts
Default maintenance
intervals
Operation
Filter change
Operation
Filter change
Replacing electrical
replacement parts
Care and maintenance
WARNING
Before doing any work on the machine, pull
the plug out of the socket. Leave the unit to
cool down.
Check all connected cables and hoses on a regular basis. If
removed from use.
for at least 3 minutes until the soldering tip has cooled down.
The LED status indicator must be at „OFF".
Keep the heat transfer surfaces of the soldering tip and
heating element clean. The heating element must not come
into contact with soldering tin.
Repairs must always be referred to a Weller-trained
specialist.

Warranty

accordance with §§ 478, 479 BGB (German Federal Law
Gazette).
persons.
16
User groups
Specialist personnel with
technical training
Electricians
Non-specialists
Technical trainees under
the guidance and supervi-
sion of a trained expert
For more information please visit
www.weller-tools.com.
Technical Data
soldering station
Dimensions L x W x H
Weight
Power consumption
Temperature range
Tool dependent
Soldering iron
Temperature range
Power consumption
Heat-up time
(50°C to 350°C) (120°F to
660°F)
Tip top condition
Subject to technical alterations and amendments.
Temperature performance
The soldering tool has an internal usage sensor which can
The settings can be found in the station's operating instruc-
tions.
WE 1
(mm) 150 x 125 x 100
(Inch) 5,91 x 4,92 x 3,94
(kg) 1,9
( V / Hz) 230 / 50/60
120 / 60
100 / 50/60
(W) 85
I, antistatic housing
III, Soldering tool
(°C) 100 - 450
200 - 850
(°F)
(°C/°F) Average tip tem-
perature can be
„offset" to +/- 5°C
(+/-°9F) at idle with
no load
(°C/°F) ± 6 / ± 10
WEP 70
(°C / °F) 50-450
(W) 70
(V AC) 23
(s) 28
ET
WE 1