Optoma BX-AL133 User Manual page 10

Remote Control and Motor Operation
The LED indicator on the sled will glow when the unit is ON, and flash when any button is
pressed. It will also flash when the lens is in motion. The LED will be off in standby mode.
8-Button Remote Control
LENS OUT
PANEL OFF
SLOW
For more information, please visit our website at:
http://www.OptomaUSA.com
OFF ON
LENS IN
PANEL ON
FAST
Buttons:
OFF – Puts the sled in standby mode.
ON –Turns the sled from standby to ON.
LENS OUT – Commands the lens to move
into the LENS OUT position.
Holding the button for several seconds
re-programs the current position as the
new LENS IN position. The lens sled will
acknowledge the request by flashing the
LED and moving the lens to the new LENS
OUT position (the opposite side).
LENS IN – Commands the lens to move
into the LENS IN position (as configured in
Setup).
PANEL OFF – Turns the logo backlight off.
PANEL ON – Turns the logo backlight on.
SLOW – Sets the acceleration/deceleration
and maximum speed for slow (low inertia)
traversal.
FAST – Sets the acceleration/deceleration
and maximum speed for rapid traversal.
User's Manual
BX-AL133
User's Manual |
10