Table of Contents
Advertisement
MAINTENANCE
To reduce the risk of injury, always
WARNING
unplug the charger and remove the
battery pack from the charger or machine before
performing any maintenance. Never disassemble
the machine, battery pack or charger. Contact a
MILWAUKEE
service facility for ALL repairs.
®
Maintaining Machine
Keep your machine, battery pack and charger in
good repair by adopting a regular maintenance
program. Inspect your machine for issues such as
undue noise, misalignment or binding of moving
parts, breakage of parts, or any other condition that
may affect the machine operation. Return the
machine,
battery
MILWAUKEE
service facility for repair. After six
®
months to one year, depending on use, return the
machine,
battery
MILWAUKEE
service facility for inspection.
®
If the machine does not start or operate at full power
with a fully charged battery pack, clean the contacts
on the battery pack. If the machine still does not work
properly, return the machine, charger and battery
pack, to a MILWAUKEE
ONE-KEY™
Chemical Burn Hazard.
WARNING
This device contains a
lithium button/coin cell battery. A new
or used battery can cause severe in-
ternal burns and lead to death in as
little as 2 hours if swallowed or enters the body.
Always secure the battery cover. If it does not
close securely, stop using the device, remove the
batteries, and keep it away from children. If you
think batteries may have been swallowed or en-
tered the body, seek immediate medical attention.
Internal Battery
An internal battery is used to facilitate full ONE-KEY™
functionality.
To replace the battery:
1. Remove the battery pack.
2. Remove the screw(s) and open the battery door.
3. Remove the old battery, keep it away from children,
and dispose of it properly.
4. Insert the new battery (3V CR2032), with the posi-
tive side facing up.
5. Close the battery door and tighten the screw(s)
securely.
T
o reduce the risk of personal in
WARNING
jury, electric shoc
never immerse your machine in liquid or allow a
Cleaning
Clean dust and debris from vents. Keep handles
clean, dry and free of oil or grease. Use only mild
soap and a damp cloth to clean, since certain clean-
ing agents and solvents are harmful to plastics and
other insulated parts. Some of these include gasoline,
turpentine, lacquer thinner, paint thinner, chlorinated
cleaning solvents, ammonia and household deter-
gents containing ammonia. Do not spray the machine
or battery.
solvents around machines.
pack,
and
charger
pack
and
charger
service facility for repairs.
®
k and damage
Cleaning the Battery and Battery Bay
Keep battery connections and surfaces between the
machine and battery free of debris and materials.
Failure to keep surfaces clean may result in mis-
alignment and/or damage to the battery connection.
For repairs, return the machine to the nearest ser-
vice centre.
WARNING
For a complete listing of accessories, go online to
www.milwaukeetool.com.au /
www.milwaukeetool.co.nz or contact a distributor.
to
a
to
a
-
,
6
Repairs
ACCESSORIES
Use only recommended accesso-
ries. Others may be hazardous.
Advertisement
Table of Contents
