Functional Description - Milwaukee MX FUEL MXF CVBP Operator's Manual

FUNCTIONAL DESCRIPTION

2
1
11
12
13
14
1. Backpack
2. Backpack latch
3. Carry handle
4. Coupler locking
handle
5. Flex shaft coupler
6. Remote storage
7. Transmit LED
8. Pairing button
ASSEMBLY
Recharge
WARNING
manual supplied with your charger and battery.
Removing/Inserting the Battery
To remove the battery, push the battery latch lock
to the side and squeeze the battery latch lever. Pull
the battery pack away from the machine.
Always remove battery pack before
WARNING
changing or removing accessories.
To insert the battery, slide the pack into the body of
the machine. Make sure it latches securely into place.
Only use accessorie
WARNING
recommended for this machine.
Others may be hazardous.
3
4
7
5
6
17
16
15
10. Start/Stop button
11. Remote mode
position
12. OFF position
13. ON position
14. ONE-KEY indicator
15. Cold Start LED
16. Arm button
17. Pairing button
onl y with th e ch
for the battery . For
Attaching the Flex Shaft
Flex shafts are normally lubricated from the
manufacturer from one end. Attach the greased end
to the machine. Use a flex shaft with a length
suitable for the job.
1. Remove the battery pack.
WARNING
changing or removing accessories.
2. Open coupler locking handle.
3. Place the flex shaft into the coupler.
4. Pull the flex shaft until the coupler locking handle
engages. (Handle will automatically fall into place
8
with an audible click)
Attaching Head to Flex Shaft
9
1. Remove the battery pack.
WARNING
10
changing or removing accessories.
2. Coat flex shaft threads with sealant to prevent
water from entering head
3. Thread head onto flex shaft.
4. Tighten by gripping metal portion of the flex shaft
and flats of the head.
Putting on the Backpack
1. Ensure backpack is securely latched to base.
2. Pick up the backpack by one of the shoulder
straps, slide your arms through each shoulder
strap.
3. With the machine on your back, tighten the
shoulder and waist straps until they fit snugly and
securely. Connect chest strap.
4. Be sure the shoulder, chest, and waist straps are
tight but comfortable; if they are too loose, the
machine may slide around on your back, making it
uncomfortable to wear.
5. Be aware machine forces may shift during use
and movement, such as twisting or bending over.
Changing Remote Batteries
Only use alkaline batteries. Do not use zinc-carbon
batteries. If the remote will not be used for a long
time, remove the batteries as a protection against
corrosion.
To change the batteries:
1. Open the battery compartment.
2. Insert the batteries according to the polarity
marked in the compartment.
3. Close the battery compartment.
arg er
spe -
1. Arm the machine.
2. On the machine, set the switch to the
3. Turn on the remote.
4. On the machine, press and hold the
until LED begins flashing (indicating machine is
ready to pair).
5. Press and hold the
flashing LED on machine will turn solid then off
when the remote has paired successfully.
NOTE: Remote needs to be within close proximity
to ensure remote is receiving signal from the
machine. This procedure will time out in 30 seconds
if machine is not paired.
4
Always remove battery pack before
Always remove battery pack before
Pairing the Remote
button on the Remote;
position.
button