Device Passed; Device Failed - Siemens FPI-32 Operation Manual

STEP 2—DEVICE PASSED
After several seconds the Programmer/Tester displays the device infor-
mation in the following format:
Where:
Device type is the device tested.
@1 = The first logical address for the device.
@2 = The second logical address for dual devices.
L Remove the device: no response necessary.
However, the following response can be entered:
YES - The Programmer/Tester displays the following message:
The Programmer/Tester is waiting for the device to be removed. Once
the device is removed, the Programmer/Tester starts the TEST mode
again from the INSERT DEVICE prompt.
NO - The Programmer/Tester returns to the Power Up sequence.
C - The Programmer/Tester returns to the Power Up sequence.
STEP 3—DEVICE FAILED
After several seconds the Programmer/Tester displays the following mes-
sage if the device failed to test properly.
L Respond:
YES - The Programmer/Tester returns to STEP 1 of the TEST mode
with the INSERT DEVICE prompt.
NO - The Programmer/Tester returns to the Power Up sequence.
C - The Programmer/Tester returns to the Power Up sequence.
firealarmresources.com
DEVICE TYPE
ADR: @1/@2, OK
INSERT NEXT DEV.

DEVICE FAILED!!

CONTINUE?
TEST MODE
17