Philips 8000 Series User Manual page 13

Replace the Remote Control
Battery
The remote control requires AAA battery.
1
To replace the batteries, open the
battery compartment on the back of
the remote control.
2
Slide the battery door in the direction
shown by the arrow.
3
Remove the old battery, which is
located in the lid, place the new AAA
battery and pay attention to the
correct polarity (+/-).
4
Reposition the battery door and
slide it back until it clicks.
2x 1
3A
1.5V
2
Precautions Concerning Batteries
When the Remote Control is not to
•
be used for a long time (more than a
month), remove the battery from the
Remote Control to prevent it from
leaking.
If the batteries leak, wipe away
•
the leakage inside the battery
1
compartment and replace the
batteries with new ones.
2x
Do not use any batteries other than AAA
•
LR03
those specified.
1.5V
Do not heat or disassemble batteries.
•
Never throw them in fire or water.
•
3
Do not carry or store batteries with
•
other metallic objects. Doing so
Click
Click
1
2
could cause batteries to short circuit,
leak or explode.
Never recharge a battery unless it is
•
confirmed to be a rechargeable type.
Leaving a battery in an extremely
•
high temperature surrounding
environment that can result in
an explosion or the leakage of
flammable liquid or gas.
A battery subjected to extremely
•
low air pressure that may result
in an explosion or the leakage of
flammable liquid or gas.
CAUTION -
Risk of explosion
•
Risk of fire or explosion if the battery is replaced
by an incorrect type.
•
Use consumer grade, non-rechargeable carbon-
zinc or alkaline batteries AAA type.
13 EN