Maintenance And Cleaning - Oase BioStyle 75 Operating Instructions Manual

Commissioning/start-up
 If there is air in the telescopic intake, it may take up to 3 minutes for the pump to
deliver water.
• Switching on: Plug the power plug into the outlet.
– The unit switches on immediately.
– Lay the power supply cord so that a drip loop is formed and the lowest point is
below the socket. This prevents dripping water from entering the socket.
– Set the desired flow rate.
• Switching off: Pull the power plug from the outlet.
Form drip loop

Maintenance and cleaning

NOTE
Do not use aggressive cleaning agents or chemical solutions. These agents can dam-
age the housing, impair the function of the device and harm animals, plants and the
environment.
Clean the unit only with clean water and a soft brush or sponge.

Adjust flow rate
BSE0003
EN
BSE0013
13