Commissioning/Start-Up; Maintenance And Cleaning - Oase CrystalSkim 350 Operating Instructions Manual

Commissioning/start-up

• Switching on: Plug the power plug into the outlet.
– The unit switches on immediately.
– Lay the power supply cord so that a drip loop is formed and the lowest
point is below the socket. This prevents dripping water from entering
the socket.
– Set the desired flow rate.
• Switching off: Pull the power plug from the outlet.
Forming a drip loop

Maintenance and cleaning

NOTE
Do not use aggressive cleaning agents or chemical solutions. These agents
can damage the housing, impair the function of the device and harm ani-
mals, plants and the environment.
 Clean the unit only with clean water and a soft brush or sponge.

Clean the unit when its performance drops noticeably.
10
Setting the flow rate
BSE0024 CRS0003