AGFA DR 10e User Manual page 25

Hold the connector straight and not at an angle, to prevent damage.
Make sure that the latches on both sides of the connector are properly
engaged when connecting the connector. If the connector is not inserted
completely, the power may turn off.
Disconnecting the cable
1. Press and hold the latches on both sides of the connector.
2. Pull the connector of the cable straight out of the connector slot of the DR
Detector.
Hold the connector straight and not at an angle, to prevent damage.
Orientation of the cable
The orientation of the connector of the DR Detector connector cable can be
changed, to fit the X-ray system in which the detector is used.
To change the orientation of the cable, contact your local service organization.
Default orientation
1.
Alternative orientation
2.
Figure 8: Orientation of the cable
Precautions for using the DR Detector connector cable
When the DR Detector connector cable is used to make an exposure on a bed,
follow the precautions below. Otherwise a load may be applied locally to the
connector, causing damage to the DR Detector.
DR 10e, DR 14e, DR 17e | Introduction to the DR Detector | 25
1 2
0370C EN 20200228 1449