Switching Off; Cleaning And Maintenance - Russell Hobbs MONTANA 10586 Instructions And Warranty

SWITCHING OFF


When the water has boiled, the kettle will switch off automatically. You can stop
the boiling process at any time by lifting the on/off switch to the "0" (off) position
or lifting the kettle off the base.
GENERAL

Always remove the kettle from the base before pouring.

To avoid the risk of splashing, pour slowly and do not over-tilt the kettle.

Do not tilt the kettle backwards - water might get on to the control area. If this
happens, let the kettle dry thoroughly before use – place it somewhere warm for
12 hours.

When you lift the kettle, you may see moisture on the base. Do not worry – it's
the steam used to switch the kettle off automatically, which then condenses and
escapes via vents under the kettle.

You may see some discolouration on the floor of the kettle. Again, do not worry –
it is due to the bonding of the element to the kettle floor.

CLEANING AND MAINTENANCE


This appliance is for household use only and is not user-serviceable.

Do not open or change any parts by yourself. Please refer to a qualified electrical
service department or return to the supplier if servicing is necessary.

Always remember to unplug the unit from the electrical outlet when not in use
and before cleaning. Ensure that the speed control is set to "0".

It is much easier to clean the accessories directly after they have been used.
Wash them in warm, soapy water, rinse and dry well.

The body of the appliance and the stand should be cleaned with a damp cloth.
Do not let water enter the appliance or the stand.

Do not use bleach or other abrasive substance or solvents to clean your
appliance as it can be damaging to the finish.

Do not immerse the appliance in water or any other liquid, or hold it under a
running tap to clean.
7