Siemens SIMATIC NET SCALANCE W760 Operating Instructions Manual page 35

Follow the steps below to fit the SCALANCE W760/W720 to a DIN rail:
1. Place the device on the upper edge of the DIN rail as shown in the figure.
2. Press the device against the DIN rail until the DIN rail slider catch locks in place.
3. Mount the connecting cables and the antenna, see section "Connecting up (Page 37)".
Procedure when removing
Follow the steps below to remove the SCALANCE W760/W720 from a DIN rail:
1. Turn off the power to the device.
2. Disconnect all connected cables.
3. Press the release button on the top of the device to release the DIN rail catch.
4. Tilt the SCALANCE W760/W720 forward and remove the device from the DIN rail.
SCALANCE W760 / W720
Operating Instructions, 03/2022, C79000-G8976-C322-13
Installation and removal
5.2 Installing on a DIN rail / removing
35