Nautilus T514 Assembly And Owner's Manual page 37

No Heart Rate display while using chest
strap
Walking belt not aligned
Motor sounds strained or E1 error occurs Silicone lubrication on walking belt
Hesitation or walking belt slips when in
use
Belt stops moving while in use
HR cable connection at Console
Sensor grip
Dry or calloused hands
Transmitter contact with skin
Electromagnetic interference
Chest strap transmitter
HR receiver
Machine leveling
Walking belt tension and alignment
Belt tension
Safety key
Motor overload
37 37 37
Insure cable is connected securely to
Console. All wires in cable should be
intact. If any are cut or crimped, replace
cable.
Insure hands are centered on HR
sensors. Hands must be kept still with
relatively equal pressure applied to each
side.
Sensors may have difficulty with dried
out or calloused hands. A conductive
electrode cream such as Signacreme®
or Buh-Bump™ can help make better
conduct. These are available on the
web or at medical or some larger fitness
stores.
Moisten skin contact area on the chest
strap.
Turn off any television, AM radio,
microwave, or computer within 6 feet (2
meters) of the treadmill.
Test chest strap with another HRM
device such as HR watch or a machine
at a gym. If transmitter has good skin
contact and still does not send a HR
signal, replace chest strap transmitter.
If chest strap is known to work with other
devices and no sources of interference
are present, or console is tested with a
Pulse Simulator and does not receive
the signal, contact Customer Care for
replacement HR receiver.
Make sure the machine is level. Refer to
the procedure for leveling the machine
in this manual.
Make sure the walking belt is centered
and tension is correct. Refer to the
procedures for adjusting tension and
aligning the belt in this manual.
Apply silicone to the inner surface of the
walking belt. Refer to the belt lubrication
procedure in this manual.
Adjust the belt tension at the rear of the
machine. Refer to the procedure for
adjusting belt tension in this manual.
Plug Safety Key into Console. (See
Emergency Stop Procedure in the
Important Safety Instructions section.)
Unit may be overloaded and draw too
much current, which causes power
to turn off to protect motor. Refer
to maintenance schedule for belt
lubrication. Make sure the walking belt
tension is correct, and start unit again.