Diamond ROME LINE RO10/B5-R2 Technical Instructions

Diamond ROME LINE RO10/B5-R2 Technical Instructions

Serve-over counter

Advertisement

Mod: ROME LINE
Code Fabricant
TB100PSSND97H
TB150PSSND97H
TB200PSSND97H
TB250PSSND97H
TB300PSSND97H
TB100PSSG110H
TB150PSSG110H
TB200PSSG110H
TB250PSSG110H
TB300PSSG110H
08/2021
Réf : Diamond
RO10/B5-R2
RO15/B5-R2
RO20/B5-R2
RO25/B5-R2
RO30/B5-R2
RO10/E8-R2
RO15/E8-R2
RO20/E8-R2
RO25/E8-R2
RO30/E8-R2

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ROME LINE RO10/B5-R2 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Diamond ROME LINE RO10/B5-R2

  • Page 1 08/2021 Mod: ROME LINE Code Fabricant Réf : Diamond TB100PSSND97H RO10/B5-R2 TB150PSSND97H RO15/B5-R2 TB200PSSND97H RO20/B5-R2 TB250PSSND97H RO25/B5-R2 TB300PSSND97H RO30/B5-R2 TB100PSSG110H RO10/E8-R2 TB150PSSG110H RO15/E8-R2 TB200PSSG110H RO20/E8-R2 TB250PSSG110H RO25/E8-R2 TB300PSSG110H RO30/E8-R2...
  • Page 2 Te c h n i c a l i n s t r u c t i o n s SERVE-OVER COUNTER...
  • Page 3 - to expose the equipment to the atmospheric agents (sun, snow, rain, etc.); - to wash the equipment with water jets; - to allow children to use the equipment without adult supervision and make sure that they do not play with the equipment;...
  • Page 4: Handling And Transport

    maintenance personnel and generally to all the pe- 4. UNPACKING ople that for different reasons have to operate with the equipment. The packing materials can be recycled, therefore they must not be dispersed, but they have to be disposed in the special waste plan for recycling.
  • Page 5: Installation

    the exchange of air in the environment even when the room is closed: Max. allowed ambient R.H. Max allowed relative temperature humidity +25°C During the installation procedure, it is prohibited to: In case the ambient conditions are not included in - Tilt the cabinet, as the lubricating oil contained in the above mentioned ones, a lower performance the cabinet itself could enter the cold circuit and the...
  • Page 6 be assembled by qualified people after the equip- - The cable of the equipment should be checked re- ment has been positioned on its place. The assem- gularly. If it should result that the cable is damaged bling instructions are contained in the envelope that or deteriorated, disconnect the equipment and do is supplied inside the packing.
  • Page 7 13. LOADING INDICATIONS - the equipment is positioned in an ambient with higher temperature or relative humidity than above indicated - the amount of displayed goods exceeds the maximum This refrigerated cabinet is proper for the preservation of recommended and the proper air circulation is prevented. foodstuffs if the following rules are respected: In those cases the goods are kept at higher temperatures, a) arrange the goods in the space provided in such a...
  • Page 8: Emergency Situations

    display surface, the shelves, the glasses with specific proceed as indicated at paragraph 16); cleaners for any surface. - if the condenser is clean (paragraph 18); - if there are air draughts, if the cabinet is installed in the correct position (see paragraph 9) and if the Do not use acid and alkaline detergents, chemical ambient temperature is as indicated (see paragraph / organic solvents, unknown chemical composition...
  • Page 9 Keep the counter away from free fl ames or sources of ignition. IN CASE OF DAMAGE Keep the counter away from free fl ames or sources of ignition Thoroughly ventilate the area for a few minutes. Swi- tch off the counter and disconnect the power plug. Contact customer service.

Table of Contents