Table of Contents
Advertisement
Table A6 - Memorising other transmitters with a previously memorised transmitter in Mode I
01. Press any key three times of a previous, memorised transmitter.
02. Press the same key three times of a new transmitter.
03. Press the same key three times of a previous, memorised transmitter.
04. Press the same key of the new transmitter.
05. If the memorisation procedure is successful, the LED emits 3 red flashes.
06. The programming procedure concludes automatically.
Note. If the memory is full (30 transmitters memorised) 6 red flashes are emitted and the transmitter cannot be memorised.
4.3 - Mode II
In Mode II each key of the transmitter can be associated with one of 8 possible commands (table A7); for example, one automation can be
controlled with just one key memorised for the toggle command, while the other keys are left free for control of other automations. In Mode II
one memorisation phase is performed for each key and each occupies one location in the memory. During Mode II memorisation, the specific
key pressed is memorised. If another key is to be assigned a command on the same transmitter, a new memorisation phase must be performed
for that specific key.
Warning! - For the partial positions to work correctly, you must perform the calibration procedure (see chapter 5.1).
Table A7 - Memorisation using Mode II
Nº
Command
1
Turn ON / Brighten UP (hold) *
2
Dimm OFF / Dimm down (hold) *
3
Toggle between OFF and the last level
4
OFF
5
Set 25%
6
Set 50%
7
Set 75%
8
ON
* Holding a key is not supported by some transmitters.
4.4 - Memorising transmitters in Mode II
Table A8 - Memorising first and other transmitters in Mode II
01. Press and hold the programming pushbutton.
02. Release the programming pushbutton when the LED illuminates with orange color (2nd position).
03. Press the programming pushbutton the number of times corresponding to the required command
(1 = brighten, 2 = dimm, 3 = toggle, 4 = OFF, 5 = set 25%, 6 = set 50%, 7 = set 75%, 8 = ON).
04. Check that the LED emits the number of long orange flashes corresponding to the required command.
05. Within 10 seconds:
Monodirectional transmitters: press and hold the required key of the transmitter to be memorized
•
for at least 3 seconds.
•
Bidirectional transmitters: press the required key of the transmitter to be memorized
06. If the memorisation procedure is successful, the LED emits 3 orange flashes.
07. Repeat steps 5 and 6 to acquire all the remotes with the same command.
08. Repeat steps 3 to 6 to acquire all the remotes with another command.
09. After 10 seconds that the device doesn't receive any signal, the programming procedure concludes auto-
matically.
Note. If the memory is full (30 transmitters memorised) 6 orange flashes are emitted and the transmitter cannot be memorised.
Example
Old
x3
New
x3
Old
x3
New
Example
1-8
1-8
MONO:
3s
BIDI:
Advertisement
Table of Contents
