Set The Easy Call Number; Dial An Easy Number; Registration; Register A Handset - Motorola D1010 Series User Manual

NOTE
EASY CALL ON
If you switch Easy call on,
in standby mode.
To switch Easy call off again:
>
1. Press .
m
OFF?
2. is displayed. Press

Set the easy call number

m d
ADVANCED SET
1. Press , scroll to
d m
EASY CALL
2. Scroll to . Press
3. Enter the master PIN (Default setting 0000) and press
d m
NUMBER
4. Scroll to . Press
m
5. Enter the number. Press
>
6. Press to return to standby.

Dial an easy number

When an easy call number has been stored and the easy call setting
switched on, press any key (apart from
NOTE
When easy call is switched on, you can still answer any incoming call as
normal.

Registration

Up to 5 handsets can be registered to one base station. Additional
handsets must be registered to the base before you can use them.
• The instructions described below apply specifically to your D1011
handset. If you wish to register another manufacturer's handset, the
instructions may vary. In this case, please refer to the manufacturer of
the additional handset.
• The Master PIN is required before you can register or unregister
0000
handsets. The default PIN is
Advanced settings
will be displayed on your screen
to confirm.
m
and press .
.
m
.
.
to confirm
>
), to dial a number.
.

Register a handset

At the base:
p
1. Press and hold the button on the base station for at least 3
seconds. The base station emits a beep when it is ready to accept
registration. You have 90 seconds in which to register a handset.
At the handset:
m d
ADVANCED SET
1. Press and scroll to
d
REGISTRATION
2. Scroll to and press
u d
3. If necessary, scroll or to display
BASE 1 2 3 4
is displayed and the registered base number is flashing.
Enter the number of the base on which you wish to register your
handset.
If you have only 1 base station, press
1 2
press or , etc.
PIN
4. When the display shows ----, enter the base PIN.
- When the handset registers with the base, it is assigned a handset
number.

Select a base

You can register your D1011 handset with up to 4 bases. Once
registered, you can switch between bases, for example, bases at home
and at work.
m d
ADVANCED SET
1. Press and scroll to
d
REGISTRATION
2. Scroll to and press
SELECT BASE
3. is displayed. Press
- The available bases are displayed with the current base number
flashing.
4. Enter the number of the base you want – 1,2,3 or 4 and press
- When the base is found you hear a beep. If not found, the display
UNREGISTERED
shows .

Unregister a handset

m d
ADVANCED SET
1. Press and scroll to
d
UNREGISTER
2. Scroll to and press
m
and press .
m
.
m
REGIST. BASE
and press
1
. If you have 2 base stations,
m
and press .
m
.
m
.
m
m
and press .
m
.
.
.
23