Table of Contents
Advertisement
06/08 Rev. AA
Loading material
CAUTION!
Rotating axles! These can pull
in and tear off hair, clothing
and jewelry.
– Do not operate the printer with
the cover open!
– Keep long hair, loose clothing,
jewelry etc. away from the
printer!
1. Open the cover.
2. Pull off the outer guide disk (1) of the
unwinder (2).
3. Place the material on the unwinder with
the corresponding adapter rings. The
material roll should turn counter-clockwise
when unwinding.
4. Replace the outer guide disk of the
unwinder.
5. Lay the material around the dancer arm.
6. Set the material guide to the material
width. Loosen the thumb screw on the
underside of the front material guide (3).
Push the material guide sideways. Tighten
the thumb screw (Fig. 2).
7. Press the red or green opener (4) of the
intake to raise the pad rollers. Press and
hold the opener and push the material
through the material guide until it is below
the printhead (Fig. 3).
8. Align the material so that it is straight.
While holding down the loading lever,
position the pad rollers so that both rollers
(5) sit symmetrically on the material. (The
printhead has been removed in Fig. 4 to
allow a better view).
QUICK REFERENCE
9864
1
2
3
4
5
Advertisement
Table of Contents
