Bartscher 60L-1F Manual page 19

Installation and operation
Appliance Start-Up / Setting
1. Plug the appliance into a suitable single socket.
2. Press and hold the ON/OFF button in the middle of the temperature controller
for at least 3 seconds to switch the appliance on.
The measured internal temperature will be shown in the digital display. The
appliance starts up with a delay.
In the case of the 700806 appliance, the inner temperature is displayed in the
temperature display at the back of the appliance (1, Fig. 1).
3. Rotate the temperature controller clockwise or counter-clockwise, until the
required temperature level is reached (1–8).
4. Press the ON/OFF button once to save the setting.
The LED temperature level indicator lights up in red with the right temperature level
setting.
The inner temperature is displayed in the digital display (temperature display).
If the ON/OFF button is not pressed, the inner temperature is displayed after 6
seconds.
NOTE!
Temperature level settings 1–8 do not represent the actual temperature
inside the appliance.
The inner temperature is higher, when the digit is lower.
The inner temperature is lower, when the digit is higher.
5. Beverages in bottles or cans should be placed in the appliance only when it
reaches the required temperature.
ATTENTION!
The appliance features cooling with circulating air, which is provided by
ventilation openings in the display area (and partition).
During filling, in order not to deteriorate the cooling effect, pay attention not to
obstruct nor block the ventilation openings.
6. If needed, the temperature may be altered with temperature controller.
700806
EN
17 / 24