BorMann BCD2510 Manual page 2

EN
Notes On Safety And Accident Prevention
This machine can only be operated safely when the operating Instructions and the safety instructions completely read and
strictly adhered to.
• Caution: The machine can begin to operate immediately when the ON/OFF switch is activated.
• When replacing drill bit or battery,as well as for transport and storage,always set the rotation direction switch to the center
position (lock - off).
• Use caution when inserting long screws: Danger of slippage.
• Always remove battery before working on machine.
• Do not leave any tool keys in place. The chuck key should always be kept in the holder provided on cable sleeve.
Equipment Protection
• Before use, ensure that the battery is properly secured in the drill.
• Do not place such loads on the drill that it ceases to turn.
• Change rotational direction only when drill is not moving.
• Use only genuine accessories.
• Battery should be protected against impact. Do not open battery. Store battery in a dry place where it is protected against
freezing.
• Battery and charger are specifically designed for use in conjunction with one another. Charging should be performed
exclusively with a charger.
• Do not expose battery to heater flames.
Danger or explosion! Do not place the battery on a heater or expose to direct sunlight for long periods. Allow warm battery to
cool before charging.
• When the battery is outside the drill,cover the contacts avoid short circuits( e.g. from tools).
• Avoid repeated consecutive rapid charges of the battery. Do not recharge after using only briefly (e.g; 3 minutes).
• Never discharge the battery completely and recharge occasionally if not used for a prolonged period.
Before Use
If the machine is new, the battery must first be charged.
Battery is housed in the handle. Swing over battery retaining clips and remove battery from handle.
A new battery or one which has not been used for an extended period achieves full performance only after approx.5 charging
and discharging cycles. A substantial drop in operating period per charge indicates that the battery is worn out and must be
replaced.
The power voltage supply must conform to that specified on the rating plate of the rapid charger.
Always inspect battery charger, cord and plug before use. Always have damage repaired by a qualified professional.
• Protect battery charger against humidity and operate only in dry areas.
• The supplied charger is suitable for charging batteries only
Charging the battery
Start the charging process by plugging in the battery charger and inserting
the battery into battery charger slot. The battery and battery charger
become warm during the charging process. This is normal.
After termination of the charging (approx.3-5h), pull charger out of socket
and remove battery.
Connector Pin
To prevent incorrect battery inserting on the Charger, please insert the
battery pack according to the position of the connector pin to the charger
as the figure.
Technical Data
Voltage: 18V
Battery Type: 1.3AH lithium
Chuck Size: 0.8-10mm
Speed: 0-400/0-1350r/min
Torque Control: 21+1
Charging Time: 1Hour
Other Specs: LED working light, LED power indicator
2
WWW.BORMANNTOOLS.COM