Table of Contents
Advertisement
ASSEMBLY GUIDE
Figure 31 hardware for pivot restrictor plate installation
Figure 32 pivot restrictor plate shown installed but loosened 2 turns for mow position
The pivot restrictor plate has 3 holes to accommodate different sizes of tractor. In most cases the bottom hole is
ideal. If the pin that goes through the slot is frequently bottoming out within the slot, try relocating it to a
different hole.
Gearbox PTO Guards
There are two remaining PTO guards. These guards are installed on the 90 degree gearbox. Install the larger,
oval-shaped guard on the front of the 90 degree gearbox, so that it is facing the tractor's PTO. See Figure 33.
2022-01.0 IBEX EQUIPMENT CO.
17
Advertisement
Table of Contents
