Table of Contents
Advertisement
ASSEMBLY GUIDE
There are 2 grease points on the mower. The first time the swivel pin is greased it will require many pumps on
the grease gun to fill up the air space around the pin. Stop when grease starts coming out around the bushings.
The spring arm has a grease point above the pivot pin.
The drivelines have grease points on the universal joints, one way clutch, and the free turning plastic shield
bearings. See the literature supplied with the driveline for manufacturers recommended lubrication procedures.
Completion checklist
If you have not done so already, adjust the tension on the two springs on the top arm so that the threaded rod is
at the half way point as is shown in Figure 2. Tighten the nut into the eye nut so that the threaded rod does not
back out of the eye nut. Both nuts in the center of the threaded rod should be tightened against each other to
keep the nuts from becoming loose.
Go back and make sure that the hardware is correctly tightened and the cotter pins have been set as to not come
loose and fall out.
2022-01.0 IBEX EQUIPMENT CO.
21
Advertisement
Table of Contents
