Table of Contents
Advertisement
ASSEMBLY GUIDE
Spring arm attachment
Figure 25 hang 3 point hitch and connect to mower
The three point hitch is joined to the mower by the swivel pin. Lift the three point hitch above the swivel pin
and raise the pin and start it in the hole with plastic bushings. Little by little, lower the three point hitch so that
the pin is through the hole completely. The support arm was held up with a cut length of 2x4 board and can be
seen in figure 25 above. The red top cap with 2 holes is placed on top of the pin and the holes are aligned. Then
the spring arm (upper arm) is aligned so that all the holes in the pin, cap and arm are aligned and then the
threaded pin shown in Figure 26 is pushed through. Install the nut and just snug - it needs to be able to pivot.
The nylon retainer will keep it from backing off. The photo in Figure 27 shows the finished assembly.
2022-01.0 IBEX EQUIPMENT CO.
14
Advertisement
Table of Contents
