Yamaha YSP10 Service Information page 106

Press the [Print] button or [Execute] button.
[Print]

To perform print feedback adjustment for the first time, press the [Print] button.
When printing process is complete, the machine stops.
[Execute]

For the second and subsequent times, press the [Execute] button.
Procedure of Printing -> mask cleaning -> Result measurement is performed automatically.
Press the Emergency Stop button. Then set the adjustment board at the conveyor
entrance or exit.
In the provided message box shown below, press [Yes] or [No] as per where you
set the board:
Conveyor entrance: press [Yes].
Conveyor exit: press [No].
The board is transferred into place and print process starts automatically.
Note
Next steps describe a procedure performed when the [Print] button is pressed. When the [Execute]
button is pressed, proceed to Step 24 of page 112.
Cancel
Yes No
SI1906002E-001=YSP10 installation and adjustment procedures
106/120
For Service Engineers
Service Information