Print Feedback Adjustment - Yamaha YSP10 Service Information

13.12. Print feedback adjustment

Print feedback adjustment is designed to correct print offsets in the X, Y and R directions. For their
measurements, mask apertures are shot by the mask camera and printed solder paste on the test board
is shot by the PCB camera.
Print feedback adjustment is performed as shown in the below steps:
Start
調整開始
Print set-up
印刷段取り
Test print
テスト印刷
Clean the mask
マスククリーニング
Edit [Print Feedback]
プリントフィードバック
screen
起動と設定
Scan reference mark
マーク認識確認
Adjust and save data
調整実行とマシ ンデータ保存
Check adjusted data
補正後の精度確認
全自動調整
Automatic adjustment
１． 基板搬入
1. Carry in test board
2. ２． 印刷 Print solder on the
board
３． マスククリーニング
3. Clean the mask
４． 測定
4. Measure results
Check results
補正値確認
Good
O K
Adjustment
調整終了
complete
SI1906002E-001=YSP10 installation and adjustment procedures
102/120
For Service Engineers
Service Information
N G
Failure
Save offset data