Print Feedback Adjustment - Yamaha YSP10 Service Information

13.12.3. Print feedback adjustment

Start the CalibSm utility.
Press the [210 Print Feedback] button.
In the provided screen, set [Measure Position Data] to "B0301 All 70 Points".
Note
When the squeegee size is smaller than 350mm, it may not be possible to print solder paste on the
left and right area of the board. In this case, select "B0301 Center 40 points".
Select the [Mask Cam Pos. Adj. Mode] option by ticking its checkbox.
Check that no board exists inside of the machine.
Ensure that this checkbox
is ticked (enabled).
SI1906002E-001=YSP10 installation and adjustment procedures
105/120
For Service Engineers
Service Information
Normally select "B0301 All 70
points". If the squeegee size is
smaller than 350mm, select
"B0301 Center 40 points".