Table of Contents
Advertisement
c. Slide the key tab under the metal tab that is on the left wall of the bay; then,
slide the key toward the rear of the chassis until the key stops (the key is
flush with the side wall, the tab is covered, and the front of the key extends
approximately 1 mm [0.04 in.] in front of the short metal upper guide).
6. Reinstall the hard disk drives in the bays from which they were removed. See
"Replacing a hot-swap hard disk drive" on page 28.
7. If you turned off the EXP3000 in step 2 on page 34, turn it on.
Chapter 4. Replacing components
35
Advertisement
Table of Contents
