Table of Contents
Advertisement
3. Turn on each connected device, according to the power-on sequence that is
4. Connect the EXP3000 power cables and turn on both power switches on the
5. Make sure that only the power (green) LEDs on the front and rear are lit. If one
6. Use the RAID controller management software as applicable to check the status
24
System Storage EXP3000: Installation, User's, and Maintenance Guide
Note: Be sure to turn on the EXP3000 before or at the same time you turn on
the device that contains the RAID controller to which the EXP3000 is
connected.
described in the documentation that comes with the device.
rear of the EXP3000.
or more of the fault (amber) LEDs are lit, see Chapter 5, "Solving problems," on
page 37 for instructions.
of the EXP3000.
Advertisement
Table of Contents
