Hopper Cover Proximity Switch (Optional); Crusher Panel Up Proximity Switch (Optional) - Labrie ALLEY -GATOR RIGHT-HAND Maintenance Manual

Hopper Cover Proximity Switch (optional)

This is an optional switch and may not be mounted on your vehicle, otherwise the hopper cover
proximity switch is mounted on the body roof next to the hopper cover cylinder.
Figure 3-34 Hopper cover proximity switch
The hopper cover proximity switch disables the lift from proceeding in an upward motion should the
hopper cover not be completely open. This proximity switch also triggers a hopper cover warning
message to appear on the MDM display screen.
How to Adjust
To adjust the hopper cover proximity switch:
Fully OPEN the hopper cover.
1.
COMPLETE the Lockout/Tagout Procedure (refer to "Lockout/Tagout Procedure" on
2.
page 20).
LOOSEN the proximity switch mounting nuts.
3.
SLIDE the switch forward or backward in the mount to achieve a gap of approximately ¼" with
4.
the tab of the hopper cover.
TIGHTEN the proximity switch nuts.
5.
TEST the operation of the switch and REPEAT the steps as necessary.
6.

Crusher Panel Up Proximity Switch (optional)

The crusher panel up proximity switch (see Figure 3-35) disables the lift from proceeding in an upward
motion should the crusher panel not be completely raised. This proximity switch also triggers a
crusher panel warning message to appear on the MDM display screen.
Maintenance 61