Table of Contents
Advertisement
4.4. Installation Steps
Installation of right-angle quick connectors
Press the movable plastic ring located at the connector port
inward so that it is flush with the port opening. Then, pull out the
1/4" plug.
Remove the 1/4" right-angle connector from the accessory bag
and insert it into the corresponding connector port as shown in
the diagram on the right.
Installation of filter cartridges
• Remove the top cover and put aside.
• Installing the filter cartridge: Remove the filter cartridge from
the product packaging, as well as the outer packaging film.
• The filter element is built into the filter cartridge canister. Insert
the filter cartridge into the respective Filter Cartridge slot
(check the filter cartridge numbering sequence) to insert it and
twist the filter cartridge canister clockwise to lock its position.
• Insert the filter cartridges one by one, in the order shown in the
diagram.
• When installing the filter cartridges, ensure that the number
indicated on the filter cartridge matches the number marked on
the water purification system.
Installation Location:
Place the machine at an appropriate location in the cabinet under the sink and ensure that it is in a
stable position.
Tubing Installation:
• Installing the inlet 3-way ball valve: Clean the installation location before shutting the main water
inlet valve. Then, dismantle the pipe faucet (simple faucet or angle valve) and install the 3-way ball
valve in its place (note: threaded connections should be sealed with Teflon tape or washers). Lastly,
re-connect the original faucet or angle valve.
• Connecting to the water inlet: Connect one end of the PE tube to the ball valve connected to the
municipal tap water pipe. Then connect the other end of the PE tube to the water inlet connecting
port (marked as "Inlet") on the main machine.
• Installing the water purification system's faucet: At the position where the faucet is to be installed,
make a mark on the stainless steel sink with a hammer and center punch (to facilitate drilling). Drill a
Φ 29mm (model: S2000-SEA) or Φ 12 mm (model: S10-SEA) hole with an electric drill and install the
faucet.
• Connection for clean water (S2000-SEA model only): Connect one end of the 1/4" straight quick-
connector onto the faucet connector marked "Clean Water". Cut an appropriate length of 1/4" PE tube
and insert one end into the 1/4" straight quick-connector; then the other end into the clean water
connector port on the water purification system.
10
Insert
1/4" right-angle
connector
Filter cartridge 3
Filter cartridge 2
Filter cartridge 1
Advertisement
Table of Contents
