Table of Contents
Advertisement
4. INSTALLATION AND COMMISSIONING
4.1 Schematic Diagram:
Filter's faucet
Faucet connector
Inlet water pipe
Wall
3-way
3/8" water tubing (white)
ball
valve
Angle
valve
4.2 Tools and materials:
Adjustable wrench, teflon tape, pipe cutter (or utility
knife), Phillips head screwdriver (for wall mounting),
pencil, drill and measuring tape.
4.3 Installation steps:
1. Switch off the cold water supply, disconnect the
cold water pipe, and open the tap to drain the water
from the pipe.
1
Unscrew the water inlet
pipe from the main faucet.
Turn the angle valve
counter-clockwise to
turn it off.
2. Connect the three-way ball valve with the angle
valve and the water supply pipe.
2
6 • EVERPURE F2100 & F2200 User's Manual
3/8" water tubing (blue)
3. Selecting the Filter's Faucet Location.
3
Pilot Hole
C
D
Ø1/4"
Ø1 1/4"
4. Drill hole for filter faucet installation
NOTE:
The drinking water faucet should be positioned with function,
convenience, and appearance in mind. An adequate flat area is
required to allow faucet base to rest securely. The faucet fits
through a 1/4" hole. Most sinks have pre-drilled 1-3⁄8" or 1-1⁄2"
diameter holes that may be used for faucet installation. If these
predrilled holes cannot be used or are in an inconvenient location,
it will be necessary to drill a 1/4" hole in the sink to accommodate
the faucet.
This procedure may generate dust which can cause
CAUTION
severe irritation if inhaled or come in contact with the
eyes. The use of safety glasses and respirator for this
procedure is recommended.
CAUTION
DO NOT ATTEMPT CAUTION TO DRILL THROUGH AN
ALL-PORCELAIN SINK. If you have an all-porcelain
sink, mount the faucet in pre-drilled sprayer hole or
drill through countertop next to sink.
CAUTION
When drilling through a countertop, make sure the
area below the drilled area is free of wiring and piping.
Make certain you have ample room to make the proper
connections to the bottom of the faucet.
CAUTION
Do not drill through a countertop that is more than
1" thick.
CAUTION
Do not attempt to drill through a tiled, marble, granite
or similar countertop. Consult a plumber or the
countertop manufacturer for advice or assistance.
A. Line bottom of sink with newspaper to prevent metal
shavings, parts, or tools from falling down the drain.
B. Place masking tape over the area to be drilled to
prevent scratches if drill bit slips.
C. Mark hole with center punch. Use a 1/4" drill bit to drill
pilot hole.
D. Use a 3/4" drill bit and drill a hole completely through
sink.
E. Smooth rough edges with a file.
Mounting Hole
Advertisement
Table of Contents
