Pentair S2000-SEA User Manual page 11

• Connection for pure water: Connect one end of the 1/4" straight quick-connector onto the faucet
connector marked "Pure Water". Cut an appropriate length of 1/4" PE tube.Then insert one end into
the 1/4" straight quick-connector and the other end into the pure water connector port on the water
purification system.
• Connection for drain water: Prepare an appropriate length of 1/4" PE tubing and connect it to the
drain water connector port on the water purification system. Connect the other end to the drainage
pipe, ensuring proper fitting to prevent it from falling out (note: the drain water should not be
discharged into a tank without spill-over protection as overflowing may cause water spill).
• Connection for pressure tank: Remove the blue protective cover of the pressure tank. Place the
pressure tank ball valve washer onto the pressure tank ball valve and screw the ball valve onto the
pressure tank. Prepare an appropriate length of 1/4" PE tube and connect it to the "Pressure Tank"
connector port on the water purification system.
• Pressure Test: Shut the pressure tank ball valve (8 PSI). Turn on the water supply and power
supply, then turn on the faucet. Check whether the booster pump is operating normally (vibrating
mildly). After the faucet starts producing Clean and Pure water, turn off the faucet. Check various
connections for leakage for 5 minutes.
• Flushing RO membrane and Tank: See Section 5.1 System Start-up
Note:
• If the power supply is cut off after water production, the machine will stop producing water.
If there is no water flow from the faucet, check to see if the power supply is connected.
• Before using the product, please follow the steps set out in Section 5.1. to flush the filter cartridges.
*Dual faucet is applicable for
S2000-SEA only
Filtered RO
water water
Filtered (Clean) water connector (model S2000-SEA only)
RO (Pure) water connector
1/4" Tube
1/4" Tube
Faucet Wire
Power Supply
Leak Protection
11