Mocka Teneriffe Assembly Instructions

Teneriffe Cot
Assembly Instructions
Thank you for your purchase.
Please follow the instructions below for correct assembly.
A B
Medium bolt Long bolt
x4 x12
Ensure the cot is placed at a reasonable distance from curtains, blinds, heaters and
power points. Keep all medications, string, elastic, small toys or small items, such as
money, out of reach from any position in the cot.

Assembly

Care must be taken when attaching sides . Do not over-tighten screws as this can cause
damage to the cot.
Please follow the manufacturer's assembly Instructions in detail to ensure the safety
features of the cot are not compromised.

Care and Maintenance

Regularly check all screws for tightness or damage that could render the cot
unsafe. To clean - use a damp cloth, avoiding the use of detergents or abrasives.

Recommended mattress size

This cot has been manufactured for use with a mattress which measures 1300mm long x
mm wide x 100mm in thickness. The width and length are specified because it is
important that gaps between the mattress and the sides and ends of the cot will not
exceed 40mm
This is to minimize the risk of a child's limb becoming
caught in the gap. The thickness of the mattress has been specified to ensure that the
depth of the cot is greater than 500mm with the mattress base in the lower position to
minimize the risk of a child climbing or falling out of the cot.
mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore BC, QLD, 4558
C D
Small bolt Allen key
X1
x4
WARNING: TO PREVENT FALLS, THE MATTRESS BASE
OF THIS COT SHOULD BE ADJUSTED TO THE LOWEST
POSITION BEFORE THE CHILD CAN SIT UP
1