Mocka Sonata Assembly Instructions

Bunk bed

Advertisement

Sonata
Bunk Bed
Thank you for your purchase.
Please follow the instructions below for correct assembly
C
A
B
plug
small
medium
bolt x19
bolt x4
x24

Hardware Supplied

WARNING: Falls from elevated beds can be fatal and deaths have occurred
where children have fallen from elevated beds. This is relevant for all ages.
The risk is greater for younger children.
The risk of injury or death from a fall from an elevated bed compared to a
non-elevated bed is:
10x greater for 7-8 year olds
7x greater for 9-10 year olds
3x greater for 11-12 year olds
IMPORTANT STATEMENT
1. Children should be discouraged from playing on the bunk bed.
2.The bunk bed should be checked periodically to ensure that the guard-
rail, access device and other components are maintained in the correct
position and state of repair and that all connectors are tight.
WARNING: THE UPPER BUNK MUST BE MORE
THAN 2 METRES FROM ANY CEILING FAN
LIFT THE BED INTO PLACE, DO NOT DRAG, AS THIS CAN CAUSE DAMAGE
mocka.co.nz I mocka.com.au I PO BOX 18, Pinkenba QLD 4008
D
E
F
allen
nut
large
x2
key x2
bolt x2
WARNING: TOP BUNKS AND ELEVATED BEDS ARE DANGEROUS AND
ARE NOT RECOMMENDED FOR CHILDREN UNDER THE AGE OF 9

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Sonata and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Mocka Sonata

  • Page 1 THAN 2 METRES FROM ANY CEILING FAN ARE NOT RECOMMENDED FOR CHILDREN UNDER THE AGE OF 9 LIFT THE BED INTO PLACE, DO NOT DRAG, AS THIS CAN CAUSE DAMAGE mocka.co.nz I mocka.com.au I PO BOX 18, Pinkenba QLD 4008...
  • Page 2 Attach panels [3] to panel [1] and [4] using 8x small bolts (A) and tighten Attach panels [2] and [6] to panel [1] and [4] using 11x small bolts (A) and with the allen key (D). tighten with the allen key (D). mocka.co.nz I mocka.com.au I PO BOX 18, Pinkenba QLD 4008...
  • Page 3 [2] and [6], then secure into place with 12x plugs (C) on each panel. The same method for attaching slats to the bottom panels [3]. mocka.co.nz I mocka.com.au I PO BOX 18, Pinkenba QLD 4008...
  • Page 4 2x nuts (E) as shown. Tighten with the allen key (D). and tighten with the allen key (D). Once assembled lift bunk bed into place, do not drag. You’re done, enjoy! mocka.co.nz I mocka.com.au I PO BOX 18, Pinkenba QLD 4008...

Table of Contents