Advertisement

Aspen
Cot
Thank you for your purchase.
Please follow the manufacturers assembly instructions in detail
to ensure the safety features of the cot are not compromised.
A
B
8x
16x
bolt
bolt

Hardware Supplied

Ensure the cot is placed at a reasonable distance from curtains, blinds, heaters and power
points. Keep all medications, string, elastic, small toys or small items, such as money, out
of reach from any position in the cot.

Assembly

Care must be taken when attaching sides. Do not over-tighten screws as this can cause
damage to the cot.

Care and Maintenance

Regularly check all screws for tightness or damage that could render the cot unsafe. To
clean - use a damp cloth, avoiding the use of detergents or abrasives.

Recommended mattress size

This cot has been manufactured for use with a mattress which measures 1300mm long x
690mm wide x 100mm in thickness. The width and length are specified because it is impor-
tant that gaps between the mattress and the sides and ends of the cot will not exceed 40mm.
This is to minimize the risk of a child's limb becoming caught in the gap. The thickness of the
mattress has been specified to ensure that the depth of the cot is greater than 500mm with
the mattress base in the lower position to minimize the risk of a child climbing or falling out
of the cot.
Flathead screwdriver required
mocka.co.nz I mocka.com.au I PO BOX 18, Pinkenba QLD 4008
C
D
E
8x
8x
8x
bolt
nut
dowel
WARNING:
F
TO PREVENT FALLS, THE MATTRESS BASE OF THIS COT
SHOULD BE ADJUSTED TO THE LOWEST POSITION BEFORE
THE CHILD CAN SIT UP.
1x
allen key

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Aspen Cot and is the answer not in the manual?

Questions and answers

Summary of Contents for Mocka Aspen Cot

  • Page 1 500mm with the mattress base in the lower position to minimize the risk of a child climbing or falling out of the cot. Flathead screwdriver required mocka.co.nz I mocka.com.au I PO BOX 18, Pinkenba QLD 4008...
  • Page 2 [4] with 8x bolts (C). Use a flathead screwdriver to align [6] to 2x panel [7] with 4x bolts (B). Tighten all bolts with allen key (F). nuts (D) with bolts (C). Tighten all bolts with allen key (F). mocka.co.nz I mocka.com.au I PO BOX 18, Pinkenba QLD 4008...
  • Page 3 Attach 2x panel [1] to panel [4] with 4x bolts (B). Tighten all bolts with allen key (F). to panel [4] with 2x bolts (B). Tighten all bolts with allen key (F). mocka.co.nz I mocka.com.au I PO BOX 18, Pinkenba QLD 4008...
  • Page 4 Attach panel [3] to panels [1] with 4x bolts (B). Tighten all bolts with allen key (F). to panel [4] with 2x bolts (B). Tighten all bolts with allen key (F). mocka.co.nz I mocka.com.au I PO BOX 18, Pinkenba QLD 4008...
  • Page 5 Repeat steps 2, 3 and 4 by removing the side panel and moving the base to corresponding holes. Securely attach again in the adjusted position. mocka.co.nz I mocka.com.au I PO BOX 18, Pinkenba QLD 4008...

This manual is also suitable for:

Aspen

Table of Contents