Working Environment; Operator Safety - Omega CL-355A User Manual

Working environment

The calibrator units are designed to work safely under the following conditions:
Ambient temperature range: 5°C/9°F to 40°C/104°F
Humidity: Up to 95% relative humidity, non-condensing
Warning
HIGH TEMPERATURES ARE DANGEROUS: They can cause serious burns to operators and ignite combustible
material. Omega has taken great care in the design of these units to protect operators from hazards, but
operators should pay attention to the following points:

Operator Safety

All operators of Omega Engineering equipment must have available the relevant literature needed to ensure their
safety. It is important that only suitably trained personnel operate this equipment in accordance with the
instructions contained in this manual and with general safety standards and procedures. If the equipment is used
in a manner not specified by Omega, the protection provided by the equipment to the operator may be impaired.
All Omega Engineering units have been designed to conform to international safety requirements and are fitted
with a preset over-temperature cutout. If a safety problem is encountered, switch off at the mains socket and
remove the plug from the supply.
Warning:
Avertissement:
Warnung:
Aviso:
• USE CARE AND WEAR PROTECTIVE GLOVES TO PROTECT HANDS
• DO NOT put hot objects on or near combustible objects
• DO NOT operate the unit close to inflammable liquids or gases
• DO NOT place any liquid directly in your unit
• At all times USE COMMON SENSE
HIGH TEMPERATURES ARE DANGEROUS
DANGER DE TEMPERATURES ELEVEES
HOHE TEMPERATUREN SIND GEFÄHRLICH
LAS TEMPERATURAS ELEVADAS SON PELI
-3-