Panasonic TK-CB430 Operating Instructions Manual page 19

9
Reset the cartridge life of the replaced
cartridges.
❶ Press
Set
Cartridge 1 is now selected (Cartridge 1 is flashing).
O
❷ Press
Set
❸ Press
Reset
The selected cartridge flashes for 10 seconds, and then lights up.
O
10
Discharge purified water until the water is clear.
(Flush for 10 minutes or more)
" " flashes for about 10 minutes.
O
( For battery saving, display turns off after about 25 seconds.)
10 minutes after, push
is off.
Note
O New cartridges contains air inside.
By flushing the air is exhausted.
O If discharging is not enough.
• Water drip from the main spaut after the lever is raised.
• Bubblesremaininthepurifiedwater.
• Unpleasant smell or taste ramains.
O If after flushing for 10 minutes the problems above are not improved, please flush for an
additional 10 minutes.
O While water is running through the unit, check that water is not leaking from the area where
the cartridge was installed.
O Purified water may contain some black powder (activated carbon).
The amount will decrease as more water flows, so continue checking the water condition for
a while.
Important
O If the outflow has not been recovered after replacing the cartridge, please contact a dealer or
subordinate service station of Panasonic.
(for about 3 seconds).
to select the replaced cartridge.
(for about 3 seconds).
to check that "
Set
Pi
Cartridge 1 flashes
Pi
Pi
" display
❶, ❷
Set
❸
Reset
EN19