Table of Contents
Advertisement
QUICK START GUIDE
Installation
Regulations, standards, site engineering instructions etc. take precedence over these general installation
instructions.
Tools required:
•
Wire cutters and strippers
•
Cable crimpers
Step 1 - Set External Shunt Jumper - 0ption
The charger is factory configured for an internal shunt.
Set the Shunt Jumper to External if an external shunt is used.
1. Remove charger rear panel—6 screws: 3 each top and bottom.
2. Move both Shunt Jumpers HDR11 and HDR12 to RMT (External) position—pins 2-3.
3. Replace charger rear panel. Secure with 6 screws.
Jumpers in External (RMT Positions
Page 4
© 2021 ABB. All rights reserved.
•
Torque wrench - 0-65 in-lb (0-10 Nm)
•
Sockets - 5/16", 7/16, etc.
•
Screwdrivers - Philips and Flat
Version 6.0
Advertisement
Table of Contents
