Replacing Carbon Filter; Washing The Prefilter - LEITZ TruSens Z-3000 Manual

REPLACING CARBON FILTER

1. The Carbon indicator will glow red when it is time to replace
the Carbon layer.
2. Gently peel away the Prefilter from the fastener strips (Fig. E).
3. Gently peel away the used Carbon layer from the fastener
strips (Fig. F).
4. Wrap a new Carbon layer around the filter drum and attach
to the same fastener strips (Fig. G).
5. Replace the Prefilter by wrapping it around the Carbon layer
and attach to the fastener strips (Fig. H).
6. Once the purifier is powered-on, hold the Reset button until
the red Carbon indicator turns o .
Note: Carbon filter 3-pack (on page 12) will cover 3 Carbon changes
between replacing the entire HEPA drum filter assembly (on page 13).

WASHING THE PREFILTER

1. We recommend that you visually inspect the Prefilter every
month, and clean as needed. At minimum, you should
hand wash the Prefilter every time you change the Carbon
filter.
2. Gently peel away the Washable Prefilter from the fastener
strips (Fig. E).
3. Gently rinse with running water – allow Prefilter to air dry
before re-installing.
4. Replace the Prefilter by wrapping it around the filter drum
14
and attach to the fastener strips (Fig. H).
Fig. E
Fig. F
Fig. G
Fig. H