Table of Contents
Advertisement
"AIR / STRETCH" massage
[Action / position selection mode]
❶
●
EP-MAC8
EN26
After "AIR /STRETCH" is pressed, the unit will switch to the
(If there is no operation in three minutes in the movement and part
selection mode, the power supply will be disconnected automatically.)
❶
Select the movement and part for "AIR /
STRETCH" massage through ▲ or ▼
❷
Press ◀ or ▶
ㅡ
Corresponding light of the selected part will remain lit (it has
flickered before).
ㅡ
❷
Multiple parts can be selected in a single time by repeating
steps
❸
The "AIR" type and the "STRETCH" type cannot be selected
z
at the same time (except in the "AUTO" programs).
❸
Press
After "STRETCH" is selected, the unit will adjust
to the massaged part automatically
If "STRETCH" is selected, "HEAT" and "SOLE HEAT"
z
massage will both be enabled.
If "STRETCH" is selected, validate the rough shoulder
z
position before massage.
Method to cancel selected parts
Press
part flicker.
If "AUTO" programs is selected and you want to disable
z
the "AIR" or "STRETCH" type, make the corresponding
lights of the unneeded parts flicker and press
Set as you like
movement and part selection mode
Corresponding
light of the selected
movement and part
will flicker.
❶
❷
and
.
Example： For example, after
shoulders and
legs in the airbag
type are selected,
the corresponding
lights will be lit (
lights will flicker).
to make corresponding light of a selected
（EN20）
.
（EN28）
Advertisement
Chapters
Table of Contents
