Setup
(continued)
3 ) Note that the distance between the wall
and the backrest when placing
Check whether it hits the wall
EN12
(When the backrest is fully up)
More than 30 cm
More than 5 cm
(When the backrest is fully down)
Castors can be used when moving the
unit.
❶
Preparation
①
After procedures EN13 to EN14 ❶・❹
~❺, then press
②
Press
to raise the backrest
③
Press
④
Turn the power switch "关" and
remove the power plug.
❷
Movement
Lift the unit to no higher than the lower back.
Place the controller in
the controller pocket and
place the power cord on
the seat surface
Do not
hold here
Hold it by the hard part inside
Mat etc. Castor