Table of Contents
Advertisement
"AUTO" massage
❷
After selecting the program, press
The unit will be
automatically adjusted to
the massage position.
Massage
position
Raising angle: approx. 35°
If inclination angle of the unit is larger than
z
angle of the massage position, the unit will not
back to the correct position automatically.
Lean the head on the comfort
cushion
Massage
heads
The massage heads will move up slowly and
beep at the same time.
When the body's areas in contact
with the massage heads decrease,
the massage heads will stop rising
Massage
heads
EN20
(continued)
When there is a beep and the
Reclined
angle:
on the LCD of the remote controller is
approx. 18°
flickering, the massage heads may be
adjusted to the shoulders
zThere are 19 heights showing the shoulder positions.
【Adjustment mode of shoulder position】
After the shoulder position is well
adjusted, press
(Even if OK is not pressed, the product will start the
z
z
z
Max: 19
Min: 1
program automatically 15 seconds later.)
<Standard of
▪Note
shoulder position>
After the shoulder position is determined, the leg/foot massage section will probably
raise according to difference between the body height and the actual height.
( To enable the feet to reach the foot massage area when both the lower
leg warm massage and the foot (HEAT) massage function are used.)
When the "AUTO" massage is running, the shoulder position can be adjusted at any time.
( If the "MANUAL" massage mode is selected, shoulder position cannot be adjusted.)
When the "AUTO" massage is running, the unit can enter or exit the shoulder position
adjustment mode through ▲ or ▼.
sign
〈Adjustment method〉
Adjust the shoulder
position through ▲ or ▼.
( )
The massage heads will
move for about 1.5 cm
after each pressing.
to start massage
Too high
Appropriate
( Where the
tapping of the
massage heads
can be felt)
Too low
Advertisement
Chapters
Table of Contents
