Setup - Panasonic EP-MAC8 Operating Instructions Manual

Household massage lounger
Hide thumbs Also See for EP-MAC8:
Table of Contents

Advertisement

Setup

1 ) Open the packing box and take out the the
massage lounger and accessories
Check the main unit and accessories
Main Unit
Status of removal from the packing box.
(When the backrest is fully down)
Accessories
Lock switch key (1)
z
Installed on the main unit when delivered.
Comfort cushion
z
Power cord
z
2 )Set up the massage lounger
Since this unit is heavy, please be careful not to
z
hurt your back etc when moving in. (The unit to be
carried by two or more people.)
Unit weight: approx. 69 kg
When lowering the main unit please pay attention to
z
your feet and slowly lower it.
Do not release the leg/foot massage section until
z
the unit is safely placed flat.
Suddenly loosening your hand will cause the leg/
foot massage section to bounce back to the original
position.
When lifting it up to carry in and install it
If you do not hold it properly, it will cause the body to
fall and damage the floor.
Please fully recline the backrest and lift the main unit
again with the legrest put back.
Place the controller in
the controller pocket and
place the power cord on
the seat surface.
Installation
place
( lay a mat etc.)
Do not
hold here
Open the hook and put your
Hold it by the hard
hand into the groove.
part inside.
Close the surface fastener after
setting.
How to attach the
Comfort cushion:
Close the zipper on
the upper part of the
backrest.
EN11

Advertisement

Chapters

Table of Contents
loading

Table of Contents