Hall Technologies HSM-88-4K User Manual page 8

3.2.6 Making a tie starting from the OUTPUT
To tie an output to an input, perform the following steps:
1. Press the desired output button. The button for the currently tied input will
light up. Note: At this point, you can use the navigation (▲▼) buttons to view
the previous or next Output routing.
2. Press the input button you want to tie to. This will make the selected input
button blink. Blinking button designates it as a "candidate" choice; an actual
tie is not made until you press the SET button.
3. Press the SET button. If you do not press the SET button, after a few
seconds, the process times out and button lights go out.
Example: Route output 1 to input 2
3.2.7 Making a tie starting from input
Routing from the input end is similar to the above but an input can be routed to
multiple outputs.
1. Press one of the input buttons. That button will light up in solid along with ALL
the outputs currently routed from that input. Note: you can use the navigation
(▲▼) buttons to view the previous or next Input routing.
2. Select all the outputs you wish to route to. Candidate outputs can be multiple
and all will be blinking until the SET button is pressed. To remove a candidate,
press the blinking output again.
3. Press SET to apply the changes.
Example: Route Input 1 to Output 1, 2 and 3
3.2.8 Blanking Outputs
The matrix allows the output to be blanked. You can blank a particular output or you
can blank all the outputs that are connected to a specific input.
© Copyright 2018 Hall Technologies.
7