Table of Contents
Advertisement
MODE button
3
Each time you press this button , a mode is selected in a sequence that goes from AUTO,COOL, DRY, FAN, and HEAT * , as the
following:
After energization, AUTO mode is defaulted. In AUTO mode, the set temperature will not be displayed on the LCD, and the unit
will automatically select the suitable operation mode in accordance with the room temperature to make indoor room comfortable.(As
for cooling only unit,it won't have any action when it receives the signal of heating operation.)
FAN
button
4
This button is used for setting Fan Speed in the sequence that goes from AUTO,
to Auto.
SWING button
5
Press this button to set up &down swing angle, which circularly changes as below:
This remote controller is universal. If any command
indicates the guide louver swings as:
I FEEL button
6
Press this button to turn on I FEEL function. The unit automatically adjust temperature according to the sensed temperature.
Press this button again to cancel I FEEL function.
/
button
7
Press this button to achieve the on and off of healthy and scavenging functions in operation status. Press this button for the
fi rst time to start scavenging function; LCD displays "
functions simultaneously; LCD displays "
functions simultaneously. Press the button for the fourth time to start healthy function; LCD display "
to repeat the operation above.
SLEEP button
8
Press this button, can select Sleep 1 (
electrifi ed, Sleep Cancel is defaulted.
Sleep 1 is Sleep mode 1, in Cool mode: after run for one hour in sleep mode, the main unit setting temperature will increase 1
after 2 hours, the setting temperature will increase 2
this setting temperature all along; In Heat mode: after run for one hour in sleep mode, the setting temperature will decrease 1
after 2 hours the setting temperature will decrease 2
setting temperature all along.
Sleep 2 is sleep mode 2, that is air conditioner will run according to the presetting a group of sleep temperature curve.
Sleep 3- the sleep curve setting under Sleep mode by DIY:
16
*Note:Only for models with heating function.
Auto
Low speed
Low-Medium speed
Medium-High speed
,
or
". Press the button for the second time to start healthy and scavenging
" and "
". Press this button for the third time to quit healthy and scavenging
), Sleep 2 (
),Sleep 3 (
, but the maximal setting temperature is 30
, but the minimal setting temperature is 16
,
,
Medium speed
High speed
is sent out, the unit will carry out the command as
) and cancel the Sleep,circulate between these, after
Service Manual
,
,
to
then back
". Press this button again
, then the unit will run at
, then the unit will run at this
Technical Information
,
Advertisement
Table of Contents
